T.A. Flash Clean 10L

Can rejuvenate plants, and help to maximise yields.

Eventually, every growing system will develop fertiliser residue as a natural part of the growing process. This accumulation results in salt build-up that can block drippers, cause ugly accumulations on top of the soil or substrate, and will eventually cause your plants stress and/or root damage. With highly- concentrated nutrients available, and high EC levels running in many systems, nutrient lockout can also be an invisible limit on your grow.

BENEFITS

• Dissolves accumulated fertiliser salts.

• Corrects nutrient balance.

• Treats nutrient lockout.

• Nourishes microbial life and refreshes soil and coco coir.

• Maximises final stage growth (especially with FinalPart).

Specifically developed to dissolve mineral salts, FlashClean releases nutrient bonds between minerals and substrate and allows you to rinse excess residue. This release helps plants make the most of remaining fertilisers, especially in the week just before harvest.

Unlike other “flushes” and finishing products, FlashClean is not an acid, isn’t enzyme-based, and does not dump magnesium or other mineral additives into your system. With FlashClean you can give your system, and your plants, a clean slate at any stage of the growth process.

FLASHCLEAN AS A FINAL FLUSH:

Use 1 or 2 days before harvest to promote maturation and sugaring.

HOW TO USE:

Hydroponic systems: Mix 1.5 to 3ml/L of water. Use a milder solution for young or fragile plants, and a stronger one for older and stronger plants close to harvest. Should be used alone before adding fertiliser.

Final flush before harvest: Alone: Drain the old nutrient solution. Refill the hydroponic reservoir with fresh water and mix 3ml of FlashClean per litre of water. Use this solution one or two days before harvest.
After use of T.A. Bloom: Add 3ml of FlashClean per litre of water during the last 2 days before harvest to increase the sugar level of the crop.

In soil and substrates: Alone: Every 2 weeks, fill a watering can with fresh water and add 1.5 to 3ml FlashClean per litre. Soak until the solution runs out under the pot. Resume your regular fertiliser schedule with the next watering.
After use of T.A. Bloom: Add 3ml of FlashClean per litre of water during the last 2 days before harvest, to increase the sugar level of the crop.

NOTE: Always use pH-adjusted water.