T.A Flash Clean 1L

General Hydroponics FloraKleen 1L

Eventually, every growing system will develop fertilizer residue as a part of the growing process. This accumulation results in salt build-up that can block drippers, cause accumulations on the top of soil or substrate, and will cause your plants undue stress and root damage. With the concentrated nutrients available today, and high EC levels in many systems, nutrient lockout can be an invisible limit on your grow - FloraKleen solves all these problems and more:

• Dissolves accumulated fertilizer salts.

• Corrects nutrient balance.

• Treats nutrient lockout.

• Nourishes microbial life.

• Maximises final stage growth.

Developed to dissolve mineral salts, FloraKleen releases nutrient bonds between minerals and substrate and allows you to rinse excess residue. This release helps plants make the most of remaining fertilizers, especially in the crucial week just before harvest.

Unlike other “flushes”, FloraKleen is not an acid, isn’t enzyme-based, and does not dump magnesium or other mineral additives into your system.

HOW TO USE:

In recirculating hydroponic systems:

• To reset before changing nutrients (inc. before Ripen): Add 1.5 to 3 ml/L of FloraKleen to your nutrient solution and circulate for 24 hours before draining and replacing with fresh nutrient solution. Use the lower dosage for young or fragile plants, and the higher dosage for established plants/close to harvest.
• After nutrient burn or lockout: Drain the old nutrient solution, add 1.5 to 3 ml/L of FloraKleen to pH-adjusted water (you don’t need to use a full tank, just enough to circulate freely and run the system). Circulate for 24 hours before draining and adding fresh nutrient solution. Use the lower dosage for young or fragile plants, and the higher dosage for established plants.
• As a final rinse (after Ripen): Drain old nutrient solution, add 1.5 to 3 ml/L of FloraKleen to pH-adjusted water (you don’t need to use a full tank, just enough to circulate freely and run the system). Circulate for for the last two days before harvest to increase sugar levels in your crop instead of losing aroma and medicinal content with a long water flush.

In potting soil and soilless mixes including coco coir:

• To refresh before changing nutrients (inc. before Ripen), and after nutrient burn or lockout: Every 15 days (or when needed after lockout etc): fill a watering can with fresh pH-adjusted water and add 1.5 to 3 ml/L. Drench until there is runoff from the pot. Resume your regular fertiliser schedule with the next watering. Use the lower dosage for young or fragile plants, and the higher dosage for established plants.
• As a final rinse/after Ripen: Use 3 ml/L instead of nutrients during the last two days before harvest to increase the sugars level in your crop instead of losing aroma and medicinal content with a long water flush.

NB: FloraKleen can be used at any stage of growth or flowering, but do not use it more than once every two weeks.

Use FloraKleen monthly to maintain your hydroponic system or potted plants and eliminate excess salts that can accumulate over time.​